МЕТ-U1A ACCESSORIES

The below listed accessories are subject to extra charge.

HARDNESS REFERENCE TEST BLOCKS

Two hardness reference test blocks with maximum and minimum possible hardness values are used to check the accuracy of hardness tester readings and, if necessary, calibrate it.

For instance, if you are testing hardness on Rockwell "C" scale, to calibrate the hardness tester you will need two Rockwell hardness test blocks with values 25±5 HRC and 65±5 HRC.

CHANGEABLE HEADPIECES TO PROBE

Ensures secure fixation and adjustment of the probe completely perpendicular to the axis of cylindrical or spherical articles.

Reduces the hardness tester error to a minimum at the measurements of cylindrical and spherical surfaces.

PROBE SUPPORT FOR HARD-TO-REACH PLACES

While installed on the probe, enables to measure hardness in hard-to-reach areas of the article.

SHORT PROBE

Короткий датчик ультразвуковой У1/2

Датчики ультразвуковые У1 и У1/2

Short type of probe U15Sh and U50Sh is used for conducting measurements in space-restricted conditions (internal diameter surface of cases, sleeves, pipesm etc.).

Dimensions: length: 80 мм;
diameter: 40 мм.
Applied load: 15N / 50N (1,5 kgf / 5 kgf)
Tested surface roughness: 2.5Ra at the load of 15N;
4.5Ra at the load of 50N

PRECISION HOLDING FIXTURE FOR PROBE

Штатив для датчика ультразвукового У1 Штатив для датчика ультразвукового У1

Ensures stable load and perpendicular position to the tested surface at the testing of small and thin articles. It is recommended to use the precision holding fixture at the measurements of small-sized articles in hard-to-reach areas.

The use of the precision holding fixture and lapping fluid allows to reduce the testing error!

Possibilities:

  • Regulated height of probe fixing;
  • Smooth probe loading excluding the possibility of its vibration and shifts along the tested article surface.

BATTERY OPERATED GRINDER

Шлифовальная машинка на аккумуляторах

Ensures appropriate preparation of the tested area on the tested article surface.

It is an ideal addition to the preparation of unfinished, rough, corrosive metal surfaces and welding seams in the measurement zone for the hardness tester probe.

Regulated range of rotation frequency, r/min 5000 - 35000
Mass, kg 0,424
Battery charging time, h 3
Battery type LiIon
Battery voltage, V 10,8
Number of changeable accessories for grinding, cleaning, polishing, engraving, cutting and sharpening 60
Complete set Plastic case,
charging device,
operation manual,
warranty coupon

LAPPING FLUID

Притирочная смазка

Ensures secure fixation and full contact with the plate or holding fixture base at hardness measurements of small and thin articles.

© Centre "МЕТ" +7 (495) 229-75-26, 506-90-38 E-MAIL

Rambler's Top100